Path Home Students Student Organizations SkillsUSA State Conference Contest Memos Jim's Contests Electrical Construction Wiring Materials List
Jump to navigation

Electrical Construction Wiring Materials List

MATERIAL LIST
STATE ELECTRICAL CONSTRUCION WIRING SKILL CONTEST

Last Revised: 14 APRIL 2015

NOTE: No preassembly of materials except knock out closures if needed
(all knock outs must be closed prior to start of contest.)

1-100 amp MLO 120/240 volt 4 circuit load center with equipment grounding bar in addition to neutral bar

2-15 amp 1 pole breakers

2-20 amp 1 pole breaker

1-20 amp 2 pole breaker

4-4" x 1½" square metallic boxes with ½" knock outs

5-Single-gang nonmetallic box, nail-type

1-Double-gang nonmetallic box, nail-type

2-Round nonmetallic boxes, nail-type

2-Metallic utility boxes with ½" knock outs (Handy Box)

2-4" Metallic octagonal boxes with internal clamps

2-Expandable bar-hangers to fit octagon boxes

2-Single-pole switch with screw terminals only*

2-Three-way switch with screw terminals only*

1-Four-way switch with screw terminals only*

5-15 amp 110 volt duplex receptacle with screw terminals only

1-20 amp GFCI receptacle

1-20 amp 220 volt single receptacle with screw terminals only

1-Raised receptacle cover (duplex)

1-Raised GFCI cover (single-gang) for 4" square box

 

2-Keyless lampholders

16-½" EMT set-screw connecters with lock-nuts

16-½" EMT one hole straps

3'-#8-3 w/g NM Cable to use as service entry cable (SE preferred)

1- NM adapter to fit #8-4 Cable above

30'-#14 THHN white solid

30'-#14 THHN red solid

30'-#14 THHN black solid

30'-#14 THHN green solid

40'-12-2 NM WG

30'-12-3 NM WG

15'-12-4 NM WG

16-NM connectors

Box-NM staples

10-Ground screws (10-32 RHMS)

24-16-penny nails

30-#10X5/8 pan head sheet metal screws

15-Red "wirenut" wire splices

15-Yellow "wirenut" wire splices

12-Green "wirenut" grounding wire splices

 

Band Aids

NOTE: EMT will be provided at the contest site.

Device boxes on Residential project will all be nonmetallic.

Light boxes remain same as in the past.
*All switches MUST be grounding type.

Jump to content